Module
Terminal
The operator's screen at the machine. Start the work, confirm what was made, name the stop and call for help without leaving the station.
What it does
Built for the station
One work centre per screen, remembered on the tablet and run full screen on a mounted display. Buttons sized for gloves, and the queue of what comes next beside the work.
Start, pause, complete
The operator picks the operation from the queue and starts it. Time counts while it runs and stops while it is paused, against the time planned from its setup and run times.
Good, scrap and rework
Confirm quantities as often as the work suits: per shift, per box, per pallet. Scrap asks for its reason, and with a machine connected its counter is offered as the good quantity.
The stop, named where it happens
The stop button asks why, with the reasons as buttons rather than a list. A line of several machines asks which one stopped, and only the reasons for that kind of machine are offered.
Help in one press
Call maintenance, quality, material or the supervisor. The call reaches the people chosen for it, repeats until somebody is on the way, and goes further up if nobody answers.
The drawing where the work is
The operation's instructions and checklist, with their pictures and tables, and the order files, routing documents and operation documents, on the screen the work is done from.
How it works
Set up the station
Pick the work centre the tablet stands at, once, and it comes back to it after every reload. Operators sign in with their own accounts, so every start, pause and confirmation carries a name.
Run the operation
Take the next operation from the queue, start it, and confirm good, scrap and rework as the work comes off the machine. Complete it and the next operation is ready.
Explain the stop
Press stop and tap the reason, or give the reason for a stop the machine opened itself. An unplanned stop takes that machine off, so it counts in its MTBF and downtime cost, and starting again ends it.
Call for help
One press calls maintenance, quality, material or the supervisor. A maintenance call can become a fault event with the operation, and the machine, already filled in.
Stop reasons
A loss you can name is a loss you can fix
Every minute a work centre is not producing sits under a reason from your own list. The terminal makes naming a stop faster than ignoring it, and a connected machine opens the stop for you.
Your own list
Tool change, no material, cleaning, a jammed sealer: the reasons your floor already uses, in the groups it recognises, each offered only for the kinds of machine it applies to.
Planned or unplanned
A changeover or a break is expected work and leaves the machine running. An unplanned stop takes off the machine it names, and only that one: a jammed press on a line of five does not stop the other four.
Breakdowns go to maintenance
A reason that counts as a breakdown offers a fault event with the operation and the machine filled in, and completing the repair ends the stop.
Corrected, not overwritten
A supervisor puts a stop under another reason or corrects its times after the fact, and every correction is kept with who made it.
Each reason also says whether it is technical or organisational and which of the six big losses it counts as, which is what OEE in Production is built from.
Call for help
Help without leaving the machine
When the work cannot go on, the terminal calls for maintenance, quality, material or the supervisor. One press sends the call, and a second takes it back.
To the people who answer
The call reaches the roles chosen for it as a notification, and appears on the dispatch list with the work centre, the order and how long the floor has waited.
Hard to ignore
Until somebody answers that they are on the way, the call repeats every five minutes for half an hour, and after ten minutes it also reaches the people who manage production.
From call to fault
A maintenance call offers a fault event with the operation already on it, and the machine too where the work centre is a single machine.
Saying you are on the way stops the clock, and closing the call takes it off the dispatch list.
Works with
Modules are switched on per customer. Start with the ones you need and add the rest when you are ready.
See Terminal running on your own plant.
Ask for a demo with your own devices, parts and jobs.